分享打膠機的使用禁止事項
為了科學正確的操作設備，防止錯誤的操作對人身和設備的損害，延長設備的使用壽命，下面就由
雙組份打膠機廠家分享一下打膠機的使用禁止事項。
In order to operate the equipment scientifically, correctly and safely, prevent the damage of wrong operation to personnel and equipment, and extend the service life of the equipment, the two-component sealant manufacturer will share the safety precautions for the use of the sealant.
1、禁止將廢膠滴落在地面上。
1. It is forbidden to drop waste glue on the ground.
2、禁止將廢膠桶排放到工業垃圾庫。
2. It is prohibited to discharge the waste rubber bucket to the industrial garbage bin.
3、禁止在工作中接觸泵的運行部件。
3. Do not touch the running parts of the pump during operation.
4、禁止直接用手堵漏。
4. It is prohibited to plug the leakage directly by hand.
5、禁止用易燃物沖洗設備。
5. It is prohibited to flush the equipment with inflammable materials.
6、禁止超過泵及液壓元件地限制壓力使用。
6. It is prohibited to use beyond the limit pressure of the pump and hydraulic components.
此外要求非專門的維修人員，不得維修調試機器。操作者必須熟悉本機性能和機構，了解應用范圍及本工技術規程掌握操作規程。工作前操作人員必須檢查設備是否完好，氣源、電源須處于正常狀態，保護裝置完好，并符合工藝要求。操作人員須正確穿戴勞保用品。操作者不得用手或身體其他部位接觸涂膠設備；不準把涂膠口對準任何人，停止涂膠時，操作者應當鎖住扳機。工作完畢后，停止壓縮氣缸，按下停止按鈕，清理機床，清理膠閥，關閉電源與氣源并填寫好點檢表。工作完畢后或長期不用時，應關閉加熱電源與氣源。
In addition, non specialized maintenance personnel are required not to repair and debug the machine. The operator must be familiar with the performance and mechanism of the machine, understand the scope of application and the professional technical procedures of the machine, and master the safety operation procedures. Before work, the operator must check whether the equipment is in good condition, whether the air source and power supply are in normal condition, whether the safety protection device is in good condition and meet the process requirements. Operators must wear labor protection appliances correctly. The operator shall not touch the gluing equipment with his hands or other parts of his body; It is not allowed to aim the gluing port at anyone. When stopping gluing, the operator should lock the trigger. After the work is completed, stop the compression cylinder, press the stop button, clean the machine tool, clean the rubber valve, turn off the power and air supply, and fill in the spot check table. After the work is completed or when it is not used for a long time, the heating power and air supply should be turned off.
The above is about the use of glue machine safety prohibitions, I hope to help you. If necessary, welcome customers to consult http://www.jshtce.cn We will wholeheartedly provide you with excellent technical guidance and good service.
上一篇：自動打膠機的那些不為人知的小功能
下一篇：打膠機本身具備特性決定要對其好好維護
